Make an easy bracelet from hollow tube cord

Pass the end of the wired wire through a bead to be crushed, then through a "U"-shaped protection, pass the wire coming out of this protection through this bead to be crushed, leave 2 to 3 cm protruding, then crush the bead using flat-nose pliers.

Thread a separator bead (same diameter as the tube), then a 7 cm piece of tube, then another separator bead.

Then string the beads you wish, creating a symmetry that's always pleasing to the eye. For a standard-size 19 cm bracelet, the two pieces of tube take up 14 cm, leaving 4.5 cm for the central beads. On this model, there are Swarovski crystal and silver spinning tops, round Bali-style beads, natural Obsidian beads and a central Bali metal bead.

Then, symmetrically, add a Separator bead, a tube, a Separator bead and a squeeze bead. Pass through a U-shaped protection, slide the main part of the clasp through it, then pass again through the squeeze bead and the Separator bead. Pull wire tight. Cut the protruding wire flush and crush the bead. At the other end of the bracelet, thread a ring through the clip formed by the U-shaped protection and add the T-shaped part of the clasp.